audi b5 s4 bentley manual

Remove pressure plate and audi clutch disc.
Also, before you install the manual rad support, it would be a good time to install the poly snub mount if you are going.
After about 37 hours of work, I now understand why shops charge 2-3K to do this job!
I also put all the bolts and pieces I removed in ziplock bags and labeled where I got them from.This will bentley aid in getting the bolt into the tranny once the slave cylinder is in the tranny and lined.p p m /p p 6/14/2006 /p p Doing a stage 3 swap was a LOT of work /p p Page 8 of 14 /p p -Check to make sure that the SAC setting on audi the PP is good, and then install clutch disc and.Install the lines on the turbos using new crush washers.C 1985, the company continually increases technological developments.But there was still a long way manual to full production.It is definitely an adventure though if youre into that.Position the mount and use a rubber mallet bentley to pound it on!Returning Customer, enter your email address below and instructions to reset your password will be emailed to you.



We recommend keeping this box unchecked when using a handbook public or shared computer.
This is especially important on the re-install, /p p you need plenty of room.
All the equipment that survived, was dismantled and removed.
p p DOH) -Remove rad support (6 bolts plus the bumper shock bolts Don't forget the temp sensor on the lower hose m 6/14/2006 /p p Doing dead a stage 3 swap was a LOT of work /p p Page 3 of 14 /p p and.Swing AC condenser to the side and under the car (dont step on the electrical connector on the condenser!This year was released the first German car with manual left-hand drive.Install new spark plugs -Undo the 8(?) bolts holding the bellhousing on the tranny to the engine.But no, it all started handbook back in the 80s, when Audi has released a promotional video, where Audi 200 winds around eight Mercedes-Benz E-Klasse (W124) and the BMW 5-Series (E28).Also, as soon as you can reach, install dead the clutch slave cylinder (with copper lubricant piconpdf on the tip and lithium grease on the collar where it seals to the tranny) and as you are antoine doing that, put the bolt through the bracket and the cylinder.Re-install the tranny -Install new motor and tranny mounts as well as the tranny mount heat shields.You will need to install the top rear lines first and then the outer ones (you cant access the ones at the back with the frontal handbook ones in the way) /p p m /p p 6/14/2006 /p p Doing a stage 3 swap was.



Pull Bipipe with DVs -Pull intercoolers -Remove bolt from coolant hardline on block going to expansion tank and work it up and out to make room to remove the AC compressor.
Description, a guide for pulling the engine from a B5 audi b5 s4 bentley manual S4 and replacing the turbos.
Now that you have fished the engine out, you can start on the motor work.